03 Elantra GT horn replacement???

  • Thread starter Thread starter Larry C.
  • Start date Start date
L

Larry C.

Has anyone replaced the pathetic horn on their 2003 Elantra GT? I almost
got creamed today by some moron who drifted right into my lane. My horn was
useless. I want to replace it with something louder. I don't want air
horns or anything, just something I can mount in the front where the
original is and will use the same wires but is much louder. Any
suggestions? Also, I couldn't figure out how to unplug the wires from the
existing horn. I could unclip the plastic thingy (technical term) but no
matter how I pulled it wouldn't come out. I could cut the wires, and will
if necessary.
LC.
 
Larry C. said:
Has anyone replaced the pathetic horn on their 2003 Elantra GT? I almost
got creamed today by some moron who drifted right into my lane. My horn was
useless. I want to replace it with something louder. I don't want air
horns or anything, just something I can mount in the front where the
original is and will use the same wires but is much louder.
Click to expand...

Check out the bottom of this page:
http://www.gwebworks.com/elantra_gt/garage.shtml
 
I know the XG350 horn is "Plug and Play" with the 02 Santa Fe, I would
guess it is the same connector on them all and the XG350 sounds MEAN.
:)

(My wife complained about her wimpy horn also)

BTW, the XG horn is $50 new (each, low tone and high tone!)

XGCA
 
XGCA said:
I know the XG350 horn is "Plug and Play" with the 02 Santa Fe, I would
guess it is the same connector on them all and the XG350 sounds MEAN.
:)

(My wife complained about her wimpy horn also)

BTW, the XG horn is $50 new (each, low tone and high tone!)
Click to expand...

Buying 'em from J. C. Whitney is a LOT cheaper....
 
Has anyone replaced the pathetic horn on their 2003 Elantra GT? I almost
got creamed today by some moron who drifted right into my lane. My horn was
useless. I want to replace it with something louder. I don't want air
horns or anything, just something I can mount in the front where the
original is and will use the same wires but is much louder. Any
suggestions? Also, I couldn't figure out how to unplug the wires from the
existing horn. I could unclip the plastic thingy (technical term) but no
matter how I pulled it wouldn't come out. I could cut the wires, and will
if necessary.
LC.
================
Click to expand...

You can listen to some horns here. Usual disclaimers.
<http://www.wolo-mfg.com/link.htm>


S271
 
Back
Top