1992 Elantra: How can I read the Engine Control Unit Codes?

Discussion in 'Hyundai Elantra / Lantra' started by Jean Castonguay, Nov 23, 2005.

  1. Jean Castonguay

    Jean Castonguay Guest

    First of all, is it possible?

    If it is, how can I do it? My Chilton book does not explain it.

    Thank you very much for your help.
     
    Jean Castonguay, Nov 23, 2005
    #1
  2. Jean Castonguay

    hyundaitech Guest

    There's a connector in your fuse box. One of the pins provides code output
    for your engine computer, another for your trans computer. Go to
    www.hmaservice.com and register for an account. Once you get your
    password, go to service information, select your vehicle and the shop
    manual tab. In the fuel section, the manual should give you a good
    picture of the connector and the procedure for checking the engine codes.
    I've done this with an analog voltmeter and simply counted the meter
    sweeps.
     
    hyundaitech, Nov 24, 2005
    #2
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. 1992 Hyundai Elantra-severe knock/ping under any loading of engine when hot

  2. Hyundai Elantra 1992-odd engine overheating problem...

  3. How can I remove the fog-light from my 2001 Tiburon

  4. Question on the air flow measuring unit on my Elantra..

  5. 2000 Accent: won't start, can't read OBD code

  6. How far can I drive while the low fuel light is on?

  7. Elantra 1992 starter: which way from the engine to the bench?

  8. Elantra 1992: reinstalling the power steering gear box

Loading...