2006 Sonata 2.4 Timing Chain

Discussion in 'Hyundai Sonata' started by Gary Glisson, Nov 21, 2016.

  1. Gary Glisson

    Gary Glisson

    Joined:
    Nov 20, 2016
    Messages:
    1
    Likes Received:
    0
    I have a 2006 Hyundai Sonata 2.4 DOHC with timing chain. It had a noise coming from behind timing cover.Took the valve cover off and the chain was very slack between the sprockets. The oil jet for the chain was ground almost completely off. I installed a new timing chain and chain tensioner. I made sure I had the chain lined up with both marks on the camshafts and the crankshaft. I pulled the pin on the tensioner and rechecked my timing markings and all three were still good. I turned the engine over a few times and none of the marks were even close anymore. What did I do wrong?
     
    Gary Glisson, Nov 21, 2016
    #1
    1. Advertisements

  2. Gary Glisson

    Anaz

    Joined:
    Dec 15, 2016
    Messages:
    2
    Likes Received:
    0
    After the engine is turned The marks on the chain are not going to line up but the marks on the camshaft sprockets should line up if it's done right
     
    Anaz, Dec 15, 2016
    #2
    1. Advertisements

  3. Gary Glisson

    Dan

    Joined:
    Dec 29, 2017
    Messages:
    1
    Likes Received:
    0
    Hey I have a 2007 Hyundai Sonata 2.4 I am wondering where the timing on the cylinder heads lines are supposed to match up with what
     
    Dan, Dec 29, 2017
    #3
  4. Gary Glisson

    avisitor

    Joined:
    Jul 30, 2017
    Messages:
    311
    Likes Received:
    13
    Location:
    Albany, NY
     
    avisitor, Dec 29, 2017
    #4
    1. Advertisements

Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.