Attn: Hyundaitech - 2000 Sonata v6 timing belt

  • Thread starter Thread starter jusme
  • Start date Start date
J

jusme

Hyundaitech;

I am going to be replacing my sonata's timing
belt, and am wondering what else I should be seriously considering
replacing at the same time, whilst things are apart...

I seem to recall reading somewhere about a belt tensioner for the
timing belt that should probably be replaced, as it gets tired?

Anything else that is prone to fialure that I should consider
replacing at the time the belt is done?

me
 
Depending on mileage, you might also consider the water pump, but I see
that more as a matter of personal preference.

While it's apart, check the timing belt pulleys to be sure they turn
smoothly. And don't forget the obvious checking of the drive belt and
drive belt tensioner.
 
hyundaitech said:
Depending on mileage, you might also consider the water pump, but I see
that more as a matter of personal preference.
Click to expand...


The same amount of labor is required later if you do have to change the
water pump. Something to think about.
 
The vehicle has just over (barely) 60,000 miles on it... I intend to
replace the external drive belt as well, because of it's age if
nothing else. The same goes for the rad. & heater hoses... I figure
that this is going to be a lot of labor anyway, so I might as well put
new "service" parts on after having to remove the old parts to get to
the *bleeping* timing belt. Are the water pumps very expensive? what
about the timing belt pulleys? (In other words, are they inexpensive
enough to just warrant replacement to save the possible nightmare of
having one fail?)

me
 
You'll need to check with your local dealer regarding prices to make a
reasonable decision about whether it's worth replacement. I don't recall
ever seeing a timing belt pulley fail on this engine.
 

Latest posts

Back
Top