Attn HyundaiTech ; Why wont the Wheel Speed Sensor come out ?!

Discussion in 'General Motoring' started by IlBeBauck, Oct 5, 2009.

  1. IlBeBauck

    IlBeBauck Guest

    I removed the hold down bolt..but the thing wont budge. Ive tried
    whacking it a few times to loosen it along with a screwdriver to dig
    it out...but its stuck in its hole. You were right...a Mouse had
    eaten thru the wires starting right at the sensor top ...so they cant
    be reconnected. SHould i try putting a small pipe wrench on it and
    twisting it ? Whats the trick to get it out ? Thanks.
     
    IlBeBauck, Oct 5, 2009
    #1
  2. IlBeBauck

    hyundaitech Guest

    The last couple of these I've removed I've had to break apart. I
    think the last one was on a '99-'05 Sonata, and if my memory is
    correct, I unbolted the ball joint and hammered it out from the back
    side using an extension. On the Santa Fe, it may be easier to take
    the strut and tie rod end loose from the knuckle.
     
    hyundaitech, Oct 6, 2009
    #2
  3. IlBeBauck

    IlBeBauck Guest

    Thanks.
     
    IlBeBauck, Oct 6, 2009
    #3
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.