How do I replace front wheel bearings on 95 accent?

  • Thread starter Thread starter Lookin4Help
  • Start date Start date
Remove wheel.
Remove brake caliper.
Remove axle nut and wheel hub. (You'll probably need a puller).
Remove rotor from hub.
Remove ball joint nut and separate ball joint from knuckle.(You should get
help if you have no experience with this step).
Remove axle from knuckle.
Remove inner bearing and seal.
Remove bearing races (again, you should get help if you have no experience
with this step).
Remove bearing and seal from hub.
Grease new bearings.
Install new seal and bearing on hub.
Install races.
Install inner bearing and seal.
Continue reassembly in reverse order of disassembly.
 
hyundaitech said:
Remove wheel.
Remove brake caliper.
Remove axle nut and wheel hub. (You'll probably need a puller).
Remove rotor from hub.
Remove ball joint nut and separate ball joint from knuckle.(You should get
help if you have no experience with this step).
Remove axle from knuckle.
Remove inner bearing and seal.
Remove bearing races (again, you should get help if you have no experience
with this step).
Remove bearing and seal from hub.
Grease new bearings.
Install new seal and bearing on hub.
Install races.
Install inner bearing and seal.
Continue reassembly in reverse order of disassembly.
Click to expand...


Gee, you make it sound so simple. Perhaps a more detailed explanation of
removal and installation of the races - which is the crux of the process
- would be in order.
 
I figure that if the original poster needs help with removing the races or
wheel hub, then help in person is in order. We're now moving to areas
difficult to describe to someone who has never done them and perhaps easy
to mess up to the point of causing damage.
 
Back
Top