Hyundai 'Donut' Wheel/Tire

Discussion in 'General Motoring' started by Cargoman2001, Jun 10, 2004.

  1. Cargoman2001

    Cargoman2001 Guest

    We have a 'Donut' tire & wheel from our 1998 Sonata, and are quite certain it
    will work on other Hyundai's, as well as other cars. Is there any online
    source that I can check to see what other vehicles this wheel will fit? The
    bolt-holes are 3 3/16ths inch (6.8 cm) center-to-center. The reason for my
    interest is I want to sell this on eBay, and would like to make it as appealing
    to as many bidders as possible.

    Thanks for your advice.
    Lee
     
    Cargoman2001, Jun 10, 2004
    #1
  2. The bolt circle is not measured between adjacent holes, but rather
    between diagonally opposite holes. It should be 114.5mm.
     
    Brian Nystrom, Jun 11, 2004
    #2
  3. Cargoman2001

    Art Guest

    On a side note.... Everyone should check their spare tire pressure.
    I had to change a flat the other day and realized the spare was 20PSI
    low. I checked the spare in my other Hyundai and found the same
    result. Luckily we were at come and were able to use a compressor
    before putting it on the vehicle.
     
    Art, Jun 12, 2004
    #3
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.