Hyundai Trajet Tapping noise when cornering at slow speed

  • Thread starter Thread starter TheDragon
  • Start date Start date
T

TheDragon

Hi,
Anyone shed any light, when I turn a corner at slow speed, the right when
make a tapping noise. I have looked for anything loose under there and
nothing. I have even just replaced the front brakes in case something was
rubbing.

No noise at higher speeds, or in a straight line. Maybe the rocker arms, but
that would knock when the car was rocked hard. his only happens when
cornering.

Any help????
 
Tapping or clicking on corners only usually suggets CV joints. On older cars
a clean/regrease solves problem. I,m not sure on latter cars.
John
 
John said:
Tapping or clicking on corners only usually suggets CV joints. On older
cars a clean/regrease solves problem. I,m not sure on latter cars.
John
Click to expand...

As you suggested, the right CV joint has split. I will give it a good clean,
re-grease, put the boot back together and tape it up. Hope it will fix it
till I can afford to replace it.
 
TheDragon said:
As you suggested, the right CV joint has split. I will give it a good
clean, re-grease, put the boot back together and tape it up. Hope it will
fix it till I can afford to replace it.
Click to expand...

I also noticed one of the wheen nuts was missing. 4 instead of 5. On closer
inspection, the stud has sheared just inside. Where can I get a replacement
M12 stud to replace the sheared one, after its been drilled out by the
garage.

I will then have to buy a new set of wheel nuts as the current ones are not
standard, they have a M12 Hex hole in the end, not the regular M17 head.
 
Tapping or clicking on corners only usually suggets CV joints. On older cars
a clean/regrease solves problem. I,m not sure on latter cars.
                  John
Click to expand...

Clicking tends to indicate that the joint has been damaged from lack
of grease. Plan on replacing the axle assembly or outer joint.

The stud should be available at any auto parts store.
 
Back
Top